| Postgres-XC 1.0.4 Documentation | ||||
|---|---|---|---|---|
| Prev | Fast Backward | Chapter 16. Server Setup and Operation | Fast Forward | Next |
Note: The following description applies only to Postgres-XC
This section describes how to shutdown each Coordinator and Datanode. Please note that you should shutdown Coordinator first and then Datanodes, GTM-Proxy and GTM.
Note: The following description applies both to Postgres-XC and PostgreSQL if not described explicitly.
There are several ways to shut down the database server. You control the type of shutdown by sending different signals to the master postgres process.
This is the Smart Shutdown mode. After receiving SIGTERM, the server disallows new connections, but lets existing sessions end their work normally. It shuts down only after all of the sessions terminate. If the server is in online backup mode, it additionally waits until online backup mode is no longer active. While backup mode is active, new connections will still be allowed, but only to superusers (this exception allows a superuser to connect to terminate online backup mode). If the server is in recovery when a smart shutdown is requested, recovery and streaming replication will be stopped only after all regular sessions have terminated.
This is the Fast Shutdown mode. The server disallows new connections and sends all existing server processes SIGTERM, which will cause them to abort their current transactions and exit promptly. It then waits for all server processes to exit and finally shuts down. If the server is in online backup mode, backup mode will be terminated, rendering the backup useless.
This is the Immediate Shutdown mode. The master postgres process will send a SIGQUIT to all child processes and exit immediately, without properly shutting itself down. The child processes likewise exit immediately upon receiving SIGQUIT. This will lead to recovery (by replaying the WAL log) upon next start-up. This is recommended only in emergencies.
The pg_ctl program provides a convenient interface for sending these signals to shut down the server. Alternatively, you can send the signal directly using kill on non-Windows systems. The PID of the postgres process can be found using the ps program, or from the file postmaster.pid in the data directory. For example, to do a fast shutdown:
$ kill -INT `head -1 /usr/local/pgsql/data/postmaster.pid`
Important: It is best not to use SIGKILL to shut down the server. Doing so will prevent the server from releasing shared memory and semaphores, which might then have to be done manually before a new server can be started. Furthermore, SIGKILL kills the postgres process without letting it relay the signal to its subprocesses, so it will be necessary to kill the individual subprocesses by hand as well.
To terminate an individual session while allowing other sessions to
continue, use pg_terminate_backend() (see Table 9-55) or send a
SIGTERM signal to the child process associated with
the session.
Note: The following description applies both to Postgres-XC and PostgreSQL if not described explicitly.
You can shut down GTM-Proxies by sending SIGKILL, SIGTERM, SIGQUIT, SIGINT or SIGHUP to each GTM-Proxy process. GTM-Proxy process number is recorded in the file gtm_proxy.pid located in each GTM-Proxy's working directory.
Note: The following description applies only to Postgres-XC
You can shut down GTM by sending SIGKILL, SIGTERM, SIGQUIT, SIGINT or SIGHUP to GTM process. GTM process number is recorded in the file gtm.pid located in GTM's working directory.